Реклама. ООО «ЛитРес», ИНН: 7719571260.
INTRODUCTION
Contents
CHAPTER. 1. ANATOMY. LET’S MEET OUR UKULELE IN ITS FINISHED FORM FIRST, TO LEARN THE NAMES OF ALL OF ITS PARTS
AND NOW, LET’S MEET THE UKULELE IN ITS RAW-MATERIALS STATE
MATERIALS
CHAPTER. 2. TOOLS
Sanding blocks
Sharpening
Specialty tools
Grimel
Rasps and files
Bending iron
Glue
A NOTE ON CLAMPING
Go-bar deck
CHAPTER. 3. NECK AND HEAD
GLUING THE NECK TO THE HEAD
CUTTING THE NECK FLUSH WITH THE HEAD
THE HEADPLATE
THE HEAD PROFILE
CUT OUT THE PROFILE OF THE HEAD
PREPARE THE HEEL BLOCK
GLUING THE HEEI BLOCK
PRELIMINARY HEEL LAYOUT
TRACING THE NECK FORM
CHAPTER. 4. SOUNDBOARD
JOINING THE SOUNDBOARD
AN ALTERNATIVE METHOD OF MEASURING THICKNESS
AFTER 24 HOURS..
BRACING THE TOP
THE GO-BAR DECK AND GLUING THE SOUNDBOARD
HERE’S A SEQUENCE FOR THE GO-BARS THAT WORKS WELL:
SHAPING THE FAN STRUTS
BEFORE TRIMMING THE BRACES
GLUING THE TRANSVERSE BARS
SHAPING THE PROFILE
CHAPTER. 5. BACK
METHOD FOR MEASURING THE THICKNESS OF THE PLATES
THE BACK’S JOINT REINFORCEMENT
LAY OUT THE POSITIONS OF THE BACK BARS
SHAPING THE BACK BARS
CHAPTER. 6. SIDES
REFODE RENDING THE SIDES
STRAIGHTENING AN OVERLY BENT SECTION
CHAPTER. 7. ASSEMBLY
THE CURVE
THE NEXT PHASE: GLUE IN THE KERFED LININGS
HERE’S WHAT’S NEEDED
ROUNDING OVER THE EDGE OF THE LININGS
GLUING IN THE KERFED LININGS FOR THE BACK
GLUING ON THE BACK
CHAPTER. 8. BINDINGS
HOW TO CUT THE CHANNELS
BEND THE BINDING STRIPS
FILLING GAPS
CHAPTER. 9. FINGERBOARD
CHAPTER. 10. SHAPING THE NECK
SOME SANDING TECHNIQUES
CHAPTER. 11. BRIDGE
THE BRIDGE
SOME ALTERNATIVE BRIDGE SHAPES
CHAPTER. 12. FRETS
CHAPTER. 13. FINISHING
THE TOOLS YOU’LL NEED
APPLYING THE FINISH
CHAPTER. 14. SETUP
SETUP: THE NUT
SETUP: THE SADDLE
ACKNOWLEDGMENTS
Millimeter-to-Inch Conversion Table
In loving memory of John Weissenrieder
Dedicated to the 286 Kickstarter backers who helped launch this project
.....
Parts list:
Body=hardwood 2.5cm x 1.5cm x 8cm
.....