Gunsmithing: Shotguns

Оглавление

Patrick Sweeney. Gunsmithing: Shotguns

Отрывок из книги

GUNSMITHING SHOTGUNS

PATRICK SWEENEY

.....

What looks like a disassembly pin on the right side is the pivot rod for the right-hand shell stop.

To reassemble the receiver, turn the lifter until the hooked end is towards the safety, and the points of the hooks are towards the bottom of the receiver. Squeeze the rear of the lifter enough to slide it into the receiver. Press it down until the two circular bosses snap into their holes. Push the bolt into the receiver, and push the forearm back until the bolt and action bars are positioned in the rectangular slot. Place the slide plate down on the bolt, and engaging the action bars. If you do not have it in place, the forearm won't go forward, or won't take the plate and bolt with it. Replace the barrel. Run the slide forward. Turn the receiver upside down on your bench or in a padded vise. Place the shell stops in their slots, with the tabs in the space between the operating rods and the receiver. Each stop is designed to fit only in its appropriate slot. Take the trigger assembly and catch the shelf on its front into the slots in the receiver. Pivot the rear into the receiver and press the crosspin through.

.....