Читать книгу Successful Training in Gastrointestinal Endoscopy - Группа авторов - Страница 138

Intubation of the ileocecal valve is really no different than navigating an angulated turn as described above. The location of the valve is readily identifiable by the asymmetric thickened fold just above the cecum. The valve lies within the thickened fold. In difficult‐to‐identify valves, the appendiceal orifice can serve as a clue to its location. Following the concave portion of the appendiceal orifice as if it were a bow shooting an arrow, the valve should be located in the direction this “bow” would shoot the arrow.

Occasionally, the os can be seen without special maneuvering and entered directly. More often, however, navigating through the valve requires the use of the torque or dial technique to open up the folds just as described in the section “Angulated turns.” One should advance the scope just past the valve so it is just off the screen. Slight torque or dial deflection is used in the direction of the valve as the scope is very slowly withdrawn. The key to this is to only use “slight” torque or dial deflection as too great of deflection will simply hook the tip of the scope behind the valve. The tip should just lightly brush across the folds of the valve as the shaft is pulled back (Figure 6.29) (Video 6.10). Once the first fold (cecal side) is seen, the withdrawal is stopped and gradually increasing torque or deflection is used to steer the scope tip between the two folds making up the valve. Puffs of air, by tapping on the air valve, can keep the mucosa off of the lens, allowing better identification of the os. Once the os is identified, the scope shaft can be advanced, pushing the scope tip into the terminal ileum.

A common mistake of trainees is simply coming alongside the valve and trying to use all dials in hopes that the scope tip will fall into the terminal ileum. Occasionally, this does work, but as described in the previous section, this results in a very angulated scope tip and loss of the force vector (Figure 6.30). Pushing the scope in this scope configuration will simply advance the scope shaft into the base of the cecum, which often leads to paradoxical regression of the scope tip, causing it to fall out of the valve. In instances where the ileocecal valve is inverted toward the base of the cecum, advanced endoscopists will utilize a maneuver of retroflexing the scope tip in the cecum to view the valve en face. In this scope configuration, the inverted valve can then be intubated by slowing pulling back on the scope. This maneuver can create significant pressure along the cecal wall however, thus should be used cautiously and only by experienced endoscopists when cecal intubation is necessary.

Figure 6.29 Terminal ileum intubation. To intubate the ileocecal valve, the scope tip should be brought alongside the valve and gentle deflection of the tip toward the valve used as the scope is slowly drawn back. Too much deflection will often result with the scope tip simply hooking behind the valve in the cecum. Once past the first fold of the valve, the endoscopist stops withdrawing and uses a combination of torque and slightly more tip deflection to open the valve. This leaves the scope in better position to be advanced once the os is intubated.

(Copyrighted and used with permission of Mayo Foundation for Medical Education and Research.)

Figure 6.30 Incorrect TI maneuver. Like the acute turns, novice endoscopists will often rely on excessive dial controls to attempt to intubate the ileocecal valve. This makes the scope difficult to advance, typically resulting in the scope loop advancing into the cecum and the tip falling out of the valve.

(Copyrighted and used with permission of Mayo Foundation for Medical Education and Research.)