Читать книгу Photography in the Studio and in the Field - Edward M. Estabrooke - Страница 14

Water	64 ounces f.
Protosulphate of iron	4
Acetic acid	4
Alcoholic solution of tannin, 10 grains to the ounce	4

The four ounces of iron should be dissolved in the sixty-four ounces (fluid) of water, and the acetic acid and tannic alcohol added.

In using this solution, develop your plate over a large filter, which will receive all your surplus developing solution, and conduct it into a bottle for use again; drain the plate into this filter before washing, wash carefully and then place it into the fixing solution—the developing solution which has filtered through into the bottle is afterwards used in the proportion of one-half of old to one-half of the new or fresh solution. This greatly improves the high lights of the picture, and by using more or less of the old solution, effects can be produced that are impossible by any other means.

Great care should be taken to cause the developing solution to flow evenly and with one sweep, as it were, over the whole surface, so that the action may be as near as possible equal on all parts of the surface.

In a very few seconds after the action of the developer has commenced the picture will show up. The plate meanwhile should be kept in motion and the p20 solution caused to flow from side to side and from one end to the other, in order that the development may progress evenly and with the same speed on all parts.

The picture will gradually grow and brighten, until all the detail that might be expected is seen in the shadows; then pour off the remaining solution into the filter and proceed to wash the plate until all traces of greasiness disappear; when the plate is sufficiently washed and is ready to be fixed or cleared. Another developing solution is prepared as follows:

Make a 64-ounce saturated solution of protosulphate of iron, into which drop tannin solution enough to cause a precipitate, which remains undissolved after shaking, then add drop by drop pure nitric acid, until the precipitate is taken up and the solution becomes clear. To one ounce of this add water, until it tests 18 to 20 grains to the ounce by the hydrometer, then add one ounce acetic acid, which perfects the formula and constitutes the developer.