Читать книгу The Gun Digest Book of the Revolver - Grant Cunningham - Страница 9

Chapter One

Why the Revolver?

Not that long ago the preferred handgun of both police and private citizens was the double action revolver. They were carried on duty, used to protect the home, shot in competition, and held their own as plinkers and fun guns. Their operation was well known, and learning how to properly handle their long, heavy triggers was a point of pride for many firearms instructors.

In the 1970s that started to change. The autoloading pistol was migrating from military service to law enforcement, and as it gained acceptance in those arenas the general public came to see the revolver as “old-fashioned.” By the end of the century the autoloader had almost completely replaced the revolver in police service –and for a large percentage of private citizens as well.

The revolver is still a viable choice for many kinds of shooting: recreation, hunting, or self defense.

Common malfunctions like this don’t occur with a revolver.

Today it’s rare to see a revolver in a police duty holster. On occasion you’ll find a veteran officer carrying one, and in sparsely populated areas some cops prefer them for their ability to fire powerful, flat-shooting Magnum cartridges. Other than that the revolver has been relegated to the status of the backup: an arm used to supplant the primary arm should it become inoperable or lost.

Still, nearly forty percent of all handgun sales in the U.S. are revolvers. That’s because the revolver still has some advantages – some obvious, some not – over the ubiquitous auto-loader.

The revolver is generally more reliable than an autoloader of similar quality. This isn’t to say that malfunctions can’t occur with a revolver, only that they’re less common. What malfunctions do occur are almost always a function of improper reloading technique (which I’ll cover in a later chapter) or poor quality ammunition.

A malfunction that needs clearing is quite rare. The most common problem, a failure to fire, is usually solved by stroking the trigger again and using better ammo. Another common malfunction is a case caught under the extractor, which renders the gun inoperative until fixed. It is prevented by proper reloading technique.

There is a malfunction clearing process for the very rare instances not covered above, and I’ll show you that, but needing to perform the drill is quite rare. Because of this inherent reliability, less training time is expended in malfunction drills which means more time for learning the important task of shooting!

A revolver doesn’t need just the right grip to keep it running; there is no “limp wrist” malfunction with a wheelgun. Shooting from disadvantaged positions or while injured won’t stop the gun from operating.

During an actual defensive encounter, the revolver is more resistant to induced failures. The revolver isn’t jammed by clothing or incompletely ejected casings. With an autoloader, slight contact can actually slow the slide enough to induce a malfunction. That’s not an issue with the revolver, making it ideal for close-quarters defensive duties. The shrouded or concealed hammer models are about as immune to such problems as can be imagined.

Some defensive schools teach shooting while in contact with an adversary. Whether that’s an appropriate response is beyond the scope of this book, but in such cases the revolver works perfectly where the auto can be jammed at the first shot.

Because of this it’s also possible to fire a revolver from inside a pocket without fear of malfunction. Shooting the revolver from inside a purse holster is also doable (and perhaps even necessary in the event of a purse grab.) An autoloader wouldn’t be as reliable under those circumstances.

(It’s important to understand that both autos and revolvers can be deliberately rendered inoperable by a very determined assailant. It’s the inadvertent failures, those that are situationally caused, that aren’t a problem for the revolver.)

A revolver is easier to fit to the hand. An autoloader, even one of the few that feature interchangeable backstraps, is still limited by the dimensions of its magazine well. A revolver’s grip can be easily changed to be longer, shorter, deeper, shallower, wider, or thinner. The angle at which the gun sits in the hand can even be altered on some models. In most cases it’s a cinch to make the revolver fit the hand perfectly.

One overlooked feature of the revolver is that it operates without ammunition. While I’m not a big proponent of extensive dry fire, the fact that the revolver is fully functional without ammo means that dry fire training is more useful than it is with an autoloader. There’s no interruption in the firing cycle, so trigger control is learned faster than if you had to stop to constantly rack a slide. I don’t know about you, but my brain learns best when it can experience a complete cycle of an event, and this is more easily done with the revolver.

The revolver is not only less expensive to purchase, it’s less expensive to operate as well. The gun itself tends to be less expensive than an auto of equal quality, but that’s just the start!

The revolver is self contained, and doesn’t need expensive magazines to operate.

If you have a defensive autoloader, it’s imperative that you test its function with the ammunition that you plan to carry. Recommendations vary, but the most common is that you shoot 200 rounds of that ammunition through the gun. If you’ve priced ammunition lately, you know how much that can cost!

With a revolver, you need to test your ammunition primarily to adjust the sights, or to verify that the bullet impact matches your non-adjustable sights. A couple of cylinders is all that takes, and you can then substitute cheaper practice or range ammo.

Of course there are no expensive magazines to buy. If you shoot your autoloader a lot, most authorities recommend that you have a half-dozen magazines for that gun. That’s a lot of money, and magazines are disposable parts: they wear out or can be damaged relatively easily. That’s an expense the revolver doesn’t have.

It’s impossible to load rounds into a revolver backwards.

Speaking of magazines, one of my favorite revolver attributes is that there aren’t any. Sometimes I go to the range with several guns, and when I’m dealing with autoloaders more than once I’ve forgotten to bring a magazine. The revolver doesn’t have that problem because the magazine is part and parcel of the gun. Even many years from now a revolver bought today will still be operational, while I’ve run into many autoloaders over the years that are missing their magazines.

I know I’m picking on the magazine issue, but another point is that it’s impossible to load rounds into a revolver backwards. I’ve seen more than one person load a round into a magazine backwards, and that causes a heck of a jam. Admittedly the incidence goes down with familiarization, but I remember one match I shot where a seasoned competitor loaded a round backwards in the middle of his magazine. Boy, was his face red!

I’m not a fan of the word “tactical,” but there is one revolver advantage that fits the term: should you need to pick your gun up from a table (or even the ground), the protruding cylinder makes a small gap between the gun and the surface on which it’s resting. This makes it a bit easier to retrieve than an autoloader which rests flat on the surface. A small difference, to be sure, but one which could prove valuable in the event that you need to pick yours up in a hurry!

A revolver has a simple manual of arms, meaning that it is easier to handle and operate. Many people say they pick a revolver because it’s easier to manipulate: no confusing buttons or levers, and a direct and unambiguous loading and unloading procedure. This makes it a superb choice for a home defense gun in those cases where one person is an enthusiast but his or her partner may not be. Anyone can pick up a revolver and shoot it.

This manual of arms is generally consistent across all revolver makes and models. There are exceptions, of course, but they are very rare. For the overwhelming majority of double action revolvers in circulation, all of the controls are in the same place and do pretty much the same thing. If you know how to run a Ruger, being handed a Smith & Wesson is not going to make you stop and scratch your head in confusion.

Since the revolver has a long, heavy trigger it’s more immune to adrenaline-induced accidental discharge. While most trainers (including me) stress that the finger should be outside of the triggerguard unless actually shooting, we must acknowledge that not everyone does this – especially those who haven’t been formally trained. In such hands, after being startled out of bed or in stress after ordering someone on the ground, it’s probably better that the gun require significant effort to shoot.

While many revolvers today have built in locks, it’s a simple matter to lock up any revolver: simply open the cylinder and hook a padlock through the frame opening. If you have a long-shackle lock, you can even run it through one of the chambers. It’s a simple matter to simultaneously lock the gun to something immovable, making it safe from accidents and from theft as well.

It’s been said that learning to shoot a revolver well helps you shoot all guns better. I’ve found that’s true, but only if you understand the why behind the techniques. I’ll go into this in Chapter Five.

One benefit that doesn’t seem like a benefit is that the revolver isn’t an easy gun to master. I’ve said for many years that the revolver is the easiest gun to shoot but the hardest gun to shoot well. There is a personal satisfaction to shooting a revolver well, and it’s magnified when you can do it to the point that you can beat people who insist on using those newfangled self-shucking things!

Finally, many people simply feel more at home with a gun that doesn’t look like a military or police arm. I’m not of that persuasion, and I suspect you may not be either, but to many people the revolver presents a friendlier image than that of any other gun – except, perhaps, for the old lever-action rifle. If I’m taking a new person to the range, a person who has no exposure to guns and is a little apprehensive about the whole affair, I’ll let them shoot revolvers first (and perhaps exclusively.) I’m sure that some will accuse me of pandering to other’s fears, but I believe that we gain converts, or at least don’t make enemies, by presenting shooting in its most favorable light. The revolver is just the tool to do that. After all, Barney Fife carried one, and who doesn’t love Barney?!

I don’t think I’ve made much of a secret that I’m a big fan of the revolver, nor of my belief that they have a lot of advantages over autoloading pistols. I’m a partisan, of that there is no doubt, yet the revolver isn’t right for every shooter or every application.

The revolver’s rounded shapes make it easier to pick up from a table or draw from a holster.

Safety first – always keep your finger outside the trigger guard until you are ready to shoot!

First, of course, are those situations where capacity is important. The double action revolver is a great tool for personal defense, but the limited ammunition capacity makes it unsuitable for military use. Were I a police officer, particularly one assigned to an urban area where gangs and heavily armed offenders were commonplace, I doubt I’d choose a revolver as a primary arm (and I probably wouldn’t be allowed to, in any case).

While many people tout the revolver as being a good choice for those with limited upper body strength, I’m not so sure it’s always practical. Those people I’ve encountered who have strength issues with their arms or hands, such that they can’t operate an autoloading pistol, often lack the strength or range of movement to operate a revolver’s heavy double action trigger. While gunsmithing can help this to some degree, I’ve encountered many folks who just couldn’t handle the trigger weight. With proper technique those same people often were able to use an autoloader, and for them it was a better choice.

Revolvers aren’t well suited to the mounting and use of weapon lights. The presence of the ejector rod generally requires that the light be mounted very far forward, where it is difficult to actuate with the hands in a shooting position. There are revolvers on the market with mounting rails near the muzzle, but ease of operation issues have limited their popularity.

A revolver does recoil more with any given level of cartridge power than an equivalent autoloader. There have been revolvers chambered in 9mm, for instance, and they display markedly more recoil than that same cartridge in an auto of equal weight. This is because there is no reciprocating slide and recoil spring to use up any of the recoil energy. With a revolver, it’s all transmitted straight into the shooter’s hands. For those who are recoil sensitive, or whose hand strength presents control issues, the revolver is much less pleasant to shoot.

Any gun has strengths and weaknesses, and though I do love revolvers I think it’s important to acknowledge their faults. Consider carefully!