Читать книгу Fundamentals of Fixed Prosthodontics - James C. Kessler - Страница 56

The technique employed to index the intercuspal position for restoration fabrication produces an interocclusal record with the maxillary and mandibular teeth in full contact.

An impression gun is assembled in the same manner as when obtaining a centric relation record with registration material (see Fig 4-7). With the patient’s mouth slightly open, material is injected between the prepared teeth and the opposing arch (Fig 4-15). The patient is instructed to close firmly until all posterior teeth are contacting normally. The dentist parts the lips and verifies that the patient has not closed in a protrusive or working relationship. The patient is instructed to keep the teeth together until asked to open. The record is left in place until the material has hardened. The bite registration is removed from the mouth and rinsed under running tap water. It should be inspected to ensure that all of the necessary teeth have been captured. A laboratory knife with a no. 25 blade is used to cut off all excess material on the facial and lingual sides of the prepared teeth (Fig 4-16). Any material that extends over the unprepared teeth adjacent to the preparations should be removed.

Excess thickness is removed from the upper and lower surfaces of the record (Fig 4-17). On the unprepared teeth opposing the preparation(s), enough material should be removed so that little more than the cusp tip indentations remain. Any material that reproduces edentulous ridges, gingival crevices, or the central fossae of the opposing occlusal surfaces is likely to produce incomplete seating of a cast with imperfections in those areas, so it is important to eliminate it (Fig 4-18). The overall thickness of the record should be approximately 4.0 mm, with an equal amount having been removed from its upper and lower aspects.

Fig 4-17 The excess thickness from the upper and lower surfaces of the record are removed.

Fig 4-18 All material contacting soft tissue or the central fossae of the opposing occlusal surfaces is removed.

Fig 4-19 The registration is trimmed along the facial cusps to verify complete seating of the record.

Fig 4-20 The record is placed on the mandibular cast, and complete seating is confirmed.

Fig 4-21 The maxillary cast is placed in the completed record and articulated with the mandibular cast.

Fig 4-22 The mandibular cast is mounted on the articulator using the record.

To verify seating of the casts into the record, its thickness along the facial cusps of the mandibular teeth is cut through completely using a laboratory knife with a no. 25 blade (Fig 4-19). The registration is then rinsed with a hospital-grade disinfectant before proceeding.

The record is set on the mandibular cast, and its complete seating is verified (Fig 4-20). The teeth of the maxillary cast are placed completely into the index while the teeth on the opposite side of the arch and those near the preparation(s) are articulated (Fig 4-21). The record is used to articulate the casts, and the mandibular cast is mounted on the articulator (Fig 4-22).

Fig 4-23 The patient is guided into working excursions on the right (a) and left (b) sides.

Fig 4-24 Right (a) and left (b) lateral interocclusal records are made in wax wafers.