Читать книгу Home Pork Making - A. W. Fulton - Страница 19

Various devices are employed for scalding hogs, without lifting them by main force. For heavy hogs, one may use three strong poles, fastened at the top with a log chain, which supports a simple tackle, Fig. 7. A very good arrangement is shown in Fig. 8. A sled is made firm with driven stakes and covered with planks or boards. At the rear end the scalding cask is set in the ground, its upper edge on a level with the platform and inclined as much as it can be and hold sufficient water. A large, long hog is scalded one end at a time. The more the cask is inclined, the easier will be the lifting.

FIG. 8. SCALDING CASK ON SLED.

A modification of the above device is shown in Fig. 9. A lever is rigged like a well sweep, using a crotched stick for the post, and a strong pole for the sweep. The iron rod on which the sweep moves must be strong and stiff. A trace chain is attached to the upper end, and if the end of the chain has a ring instead of a hook, it will be quite convenient. In use, a table is improvised, unless a strong one for the purpose is at hand, and this is set near the barrel. A noose is made with the chain about the leg of the hog, and he is soused in, going entirely under water, lifted out when the bristles start easily, and laid upon the table, while another is made ready.

FIG. 9. SCALDING IN A HOGSHEAD.

Figure 10 shows a more permanent arrangement. It is a trough of plank with a sheet iron bottom, which can be set over a temporary fireplace made in the ground. The vat may be six feet long, three feet wide and two and one-half feet deep, so as to be large enough for a good-sized hog. Three ropes are fastened on one side, for the purpose of rolling the hog over into the vat and rolling it out on the other side when it is scalded. A number of slanting crosspieces are fitted in, crossing each other, so as to form a hollow bed in which the carcass lies, with the ropes under it, by which it can be moved and drawn out. These crosspieces protect the sheet iron bottom and keep the carcass from resting upon it. A large, narrow fireplace is built up in the ground, with stoned sides, and the trough is set over it. A stovepipe is fitted at one end, and room is made at the front by which wood may be supplied to the fire to heat the water. A sloping table is fitted at one side for the purpose of rolling up the carcass, when too large to handle otherwise, by means of the rope previously mentioned. On the other side is a frame made of hollowed boards set on edge, upon which the hog is scraped and cleaned. The right temperature for scalding a hog is 180 degrees, and with a thermometer there need be no fear of overscalding or a failure from the lack of sufficient heat, while the water can be kept at the right temperature by regulating the fuel under the vat. If a spot of hair is obstinate, cover it with some of the removed hair and dip on hot water. Always pull out hair and bristles; shaving any off leaves unpleasant stubs in the skin.