Читать книгу Hydraulic Fluid Power - Andrea Vacca - Страница 59

For the analysis of pipe flow problems, the basic Bernoulli's equation can be extended to its generalized form:

(3.25)

The generalized Bernoulli's equation (Eq. (3.25)) is written between two reference sections of a pipe flow stream: an upstream section (generally indicated with subscript 1), and a downstream section (subscript 2). At the second member, the equation includes terms denoting the presence of an energy loss, h_l, and of an energy generation, h_p. The term for energy loss represents the loss due to fluid shear between the control sections 1 and 2. The term for energy generation (h_p) includes the energy provided to the flow, for example, when pumps are present. This equation will also be used to introduce the hydraulic pumps in Chapter 6.

Here, the generalized Bernoulli's law is now applied to the whole pipe (delimited by the two control sections); the Bernoulli's equation discussed in the previous paragraph is valid only along a streamline. This implies a different evaluation for the kinetic energy. In Eq. (3.25), this kinetic energy contribution is calculated by considering the average velocity on the area, thus introducing a kinetic energy coefficient (α) to consider the actual velocity profile (Figure 3.10). Without going into the specifics of how α is calculated, which can be found, for example, in [15], one can just consider:

(3.26)

The energy loss per unit mass, h_l, is typically referred in fluid mechanics as head loss. It comprises two terms:

(3.27)

The major loss, h_major, includes the friction effects generated in all the sections of the pipe (between the reference sections 1 and 2) with constant sectional areas and flow in fully developed conditions. On the other hand, the minor loss, h_minor, includes other frictional losses caused by singularities such as sectional discontinuities of fittings, bends, and entrances.

Figure 3.10 Laminar (a) and turbulent (b) velocity profiles in a pipe, with same average velocity.

The head loss h_l expresses the energy loss per unit mass in a defined flow section. It comprises two terms, the major loss (portions with constant sectional areas) and the minor loss (singularities).

Figure 3.11 clarifies how to identify the different loss terms in a pipe flow, between two reference sections 1 and 2. After every geometrical discontinuity in the piping system, such as at the entrance or after an elbow, or a fitting, the flow requires to travel a certain length before reaching fully developed conditions. Fully developed conditions are defined when the same velocity profile is held throughout the entire length of the constant area pipe. Figure 3.11 shows the entrance region of the flow getting into the first section of the pipe (length L₁) from the tank. After the entrance region, where the flow profile is still developing, the velocity profile is constant until the 180° bend is reached. The flow at the exit of the bend enters a second constant sectional portion (length L₂) and develops along a certain travel length before reaching fully developed conditions.

A detailed description of the entrance or the developing flow region is outside the scope of this chapter, but it has been a topic of interest in many fluid mechanics problems. Hence, it is important for the reader to understand the typical approach used in pipe flow problems to describe the energy loss associated with different portions of the pipe system.