Читать книгу Common Science - Carleton Washburne - Страница 38

Table of Contents

Why ball bearings are used. There is much less friction when a round object rolls over a surface than when two surfaces slide over one another, unless the sliding surfaces are very smooth; think how much easier it is to pull a wagon forward than it would be to take hold of the wheels and pull the wagon sidewise. So when you want the least possible friction in a machine you use ball bearings. The bearings are located in the hub of a wheel. Then, instead of the axle rubbing against the hub, the bearings roll inside of the hub. This causes very little friction; and the friction is made still less by keeping the bearings oiled.

Application 14. Suppose you were making a bicycle—in which of the following places would you want to increase the friction, and in which would you want to decrease it? Handle grips, axles, pedals, tires, pedal cranks, the sockets in which the handle bar turns, the nuts that hold the parts together.

Application 15. A small boy decided to surprise his mother by oiling her sewing-machine. He put oil in the following places:

On the treadle, on the large wheel over which the belt runs, on the axle of the same wheel, on the groove in the little wheel up above where the belt runs, on the joint where the needle runs up and down, on the little rough place under the needle that pushes the cloth forward. Which of these did he do well to oil and which should he have let alone?