Читать книгу The Rheology Handbook - Thomas Mezger - Страница 178

Conversion of pressure units:

Equation 3.10

1 bar = 0.1 MPa = 105 Pa = 105 N/m2

(and 1000 psi = approx. 6.89 MPa, however, psi is not an SI-unit; see also Chapter 15.3i)

In most cases, the viscosity values of fluids are increasing with increasing pressure (fluids are gases and liquids). However, liquids are influenced very little by the pressure applied since liquids, in contrast to gases, are almost non-compressible at low and medium pressures. In order to explain the reason for this, you can imagine a volume element filled with the following materials: For gases the degree of space filling is only around 0.1 %, however, for liquids it is around 95 %, and crystalline solids are even completely filling the space. The following comparison illustrates this point: For most liquids, the fairly considerable change in pressure of Δp = 0.1 to 30 MPa (= 1 to 300 bar) causes about the same small change in viscosity like the small change in temperature of ΔT = 1 K.

Even under the enormous pressure difference of Δp = 0.1 to 200 MPa (= 1 to 2000 bar), the viscosity increase of low-molecular liquids is usually showing just a factor of 3 to 7 only. However, for highly viscous mineral oils this factor can be up to 20,000 and for synthetic oils even up to 8 million. Very high peak pressures may occur as well in natural processes as well as for technical application.

When performing deep drilling processes, per 100 m depth pressure may increase by 1MPa (10 bar) and temperature by 3 K (3 °C). Examples: Drilling fluids or muds in deep oil wells for exploration of crude oil and natural gas, or for thermal energy. In 5000 m depth should be calculated with p = 50 bis 80 MPa (500 bis 800 bar) and T = 150 °C. In HPHT gas fields (high pressure/high temperature; such as the field “Elgin“ in the Northern Sea), there are up to 110 MPa and about 200 °C. Injection pumps of modern combustion motors may reach values of punctual top pressures up to p = 210 MPa. Lubricants in cogwheels, in ball bearings and sliding bearings or in gears may be confronted with more than 1 GPa [3.9] [3.75] [3.76].

Fluids, in contrast to solids, are able to flow since their atoms and molecules can change places due to the free space in between them [3.27] [3.36]. For most liquids, the viscosity values are increasing with increasing pressure since the amount of free volume within the internal structure is decreasing due to compression, and therefore, the molecules are more and more limited in their mobility. This increases the internal frictional forces and, as a consequence, also the flow resistance. The dependence of η(p) is stronger if the molecules show a higher degree of branching.

Water does not behave like most other liquids. For T < +32 °C, at a pressure of up to p = 20 MPa (= 200 bar), above all the structure of the three-dimensional network of hydrogen bridges will be destroyed. In this temperature range, the mentioned network is relatively strong compared to the structures of other low molecular liquids. Therefore here, the viscosity values are decreasing with increasing pressure. For T > +32 °C however, water begins to behave like most other liquids, and then, viscosity increases with increasing pressure.

For further information on pressure-dependent rheological behavior: see [3.10] [3.69].

For “Mr. and Ms. Cleverly”