Читать книгу Orthodontic Treatment of Impacted Teeth - Adrian Becker - Страница 63

Efficient biomechanics are not dependent on additional gadgets. The active, tooth‐moving unit solely concerns the ectopic tooth or teeth. In order to have the facility to apply a cantilever, there need to be auxiliary tubes on the first molars. As the ectopic tooth is brought into the proximity of the arch with traction applied to an eyelet, a bracket has to be substituted to enable controlled alignment. If the tooth is severely rotated and/or tipped, the replacement of the eyelet by bonding a bracket, which carries an additional vertical slot incorporated in the bracket base, will be advised. It should be noted that uprighting and de‐rotation of the canine may be accomplished simultaneously, using a cantilever. Since light forces are used, sufficient anchorage is available with the use of a rigid base arch connecting all the other teeth and consolidating them into a single anchor unit.

If a lingual arch or transpalatal arch is necessary, Goshgarian tubes, Burstone lingual brackets or hinge cap attachments on the first molars will permit simultaneous multitasking.

In order to use only light forces, composite cantilevers may be prepared, using a stiffer section in TMA 0.017 in. × 0.025 in. and a more elastic section in TMA round 0.018 in. wire. The stiffer part will secure a tight seat in the auxiliary tube, while the elastic part delivers the needed low force.

Forces applied with a cantilever tied to the eyelet/bracket/ligature wire of the tooth to be moved creating a one‐point contact can be controlled using a Correx tension gauge (Figure 3.14).

Fig. 3.14 The use of a Correx tension gauge is recommended to measure/control the level of the applied forces with cantilevers.

Straight lengths of new materials, such as the Connecticut New Arch Wire, are bendable and produce lower forces than TMA wire [31].

Super‐elastic Nitinol wire may be used for cantilevers, when bended with the Sander Memory Maker, Khouri Bendistal pliers (Figure 3.15) or hammerhead pliers. Third‐order bends cannot conventionally be bent into super‐elastic wires without destroying the structure of the wire. With the help of the Memory Maker (Figure 3.16), it is possible to programme bends of each order into the NiTi wires, as well as torque [32].

Fig. 3.15 Khouri Bendistal pliers are reliable tools for bending wire ends and V bends.

Fig. 3.16 The Sander Memory Maker allows NiTi wire adjustments in all planes of space and torque application.