Читать книгу Cooking with spice mixes, pastes and sauces - Alex Cramer - Страница 18

Fresh herbs chopping. Depending on the purpose, herbs can be fine chopped and large chopped. Finely chopped herbs are well paired and combined with other shredded components. Such a texture is specific for various paste-like sauces and marinades. Take a note that a spice combination of such a texture cannot go through heat treatment as it can cause fading of its flavor and aroma. Largely chopped herbs preserve their flavor, aroma and texture for much longer and are perfect for various types of salsa and chutney, as well as for other heat treated spice mixes.

After the leaves are separated from stalks, they should be crushed or given a coarse texture. To achieve this, you will need a very sharp knife that will nicely cut tender leaves without turning them into mash. Stack the leaves on a cutting board, press the knife tip against the cutting board with one hand while raising and lowering the knife with swinging movements with another hand and constantly moving herbs to the middle of the blade and chopping them to the desired size. From time to time, you should sweep the chopped herb into a pile in the middle of the board and repeat the entire cutting process over again. For intense chopping of herbs, you will need to constantly repeat this process for several minutes. All movements should be easy, but at the same time certain. The knife should be held tight so that it does not slip off and injure you. If you need the herbs to be of intense grinding, then you should use a blender for these purposes while adding a little of vegetable oil. To grind the herbs in a blender, it is better to use the slowest speed to avoid rapid aroma fading from already chopped herbs.

Some cooks prefer shredding fresh herbs into thin strips – chiffonade. If you want to do the same, you need to fold leaves of, for example, basil, mint or oregano into a small pile and roll it into a tube as tight as possible. Then place this tube of leaves on a cutting board and cut it across into thin strips firmly holding the tube.