Читать книгу Raising Goats For Dummies - Cheryl K. Smith - Страница 121

To add the neck pieces to the stanchion, follow these steps:

1 Place neckpiece L between pieces I and J on the stanchion support ½ inch from the center and extending 4 inches below the bottom piece I, with the cutout area facing inward and flush with the bottoms of pieces E and F.Clamp, if needed, before proceeding.

2 Place piece K 1 inch from piece L and 4 inches past the bottom of piece I, parallel with piece L.The cutout part should be facing toward the inside. Make sure piece L can move smoothly between pieces I and J. If it can’t, remove it and sand some more; then repeat this step.

3 Measure over from one end of pieces J and I to the center and mark the centerline with a pencil.

4 Measure ½ inch over from the center and mark again.

5 With piece L lined up correctly and the pieces clamped (or with a helper holding them in place), drill through pieces I, L, and G with the -inch drill bit.

6 Drop a bolt into the drilled hole, and add the hex nut to the other side to hold it in place.

7 Add a support block (M) to each end of piece H, making sure that the side and top align.

8 Use your 1⁄8-inch drill bit to drill starter holes, and then screw them together with 1-inch deck screws.