Читать книгу The Gun Digest Book of Rimfire Rifles Assembly/Disassembly - J.B. Wood - Страница 18

Reassembly Tips:

1. When replacing the sear and trigger assembly, temporarily install the rear stock-mounting bolt in order to supply a compression surface for the sear ball bearing and spring, as shown. Remember to hook the forward trigger cross pin over the sear. Temporarily insert the bolt body to stop the sear inside the receiver. When the ball and spring are compressed, insert a small drift to hold the sear for insertion of the sear cross pin. This is a difficult operation. Keep a shop cloth or apron around the receiver to arrest the ball if it slips.

2. Be sure the trigger spring adjustment washer is installed in the proper orientation, with the locking dimples downward toward the adjustment nut, as shown. Remember that the upper end of the guide must enter its hole in the receiver before the trigger cross pin is reinserted.

3. When replacing the striker assembly in the bolt, remember that the angled lug goes at the bottom to contact the like surface on the bolt handle, as shown.

4. When the safety and its retaining plunger are installed, it will be necessary to again use a padded vise to hold the front of the bolt. Be sure the plunger is oriented as shown, and that the safety is straight across as it is inserted.

5. Before the bolt can be reinserted in the receiver, the striker must be re-cocked. Hold the front part of the bolt firmly, and turn the handle until the locking lug is at the bottom, as shown.