Читать книгу Workshop Projects - Jeff Jacobson - Страница 21

Turn the benchtop upside down, and mark locations for the leg cleats (pieces 12), using the dimensions in the section view on page 10. You’ll use these locations as a reference as you build up a support structure for the large end vise (piece 13). Begin by screwing and gluing a vise support cleat (piece 14) to the endcap, located ¾" up from the bottom (see the elevation and detail drawings on page 10). Drill pilot holes, and screw a second cleat (piece 15) to the vise support (piece 16) at the location shown on the elevation drawings. Then, dry fit the vise support to the endcap cleat, and finish drilling your pilot holes. When all the screw holes have been established, remove the screws until the legs and the laminated jaw (piece 17) are installed. At that time, you’ll also address the bench dogs (pieces 18 through 20).