Читать книгу Harper's Electricity Book for Boys - Joseph H. Adams - Страница 16

To make quick connections between wires and other parts of electrical apparatus, binding-posts are the most convenient device, since the turn of a screw binds or releases a wire instantly. Binding-posts may be made in many forms, but the simple ones that a boy will need can be made from screw-eyes, burrs, stove-bolts, and nuts, together with thin strips of metal and nails.

Five simple posts are shown in Fig. 17. A is made from a screw and two burrs, B from a screw-eye and two burrs, and C from a thin plate of metal and two screws, with oval or round heads. This last, however is more of a connector than a binding-post. The ends of the wires to be connected should be caught under the screw-heads or between the burrs before the screws are driven down.

In D a simple arrangement of a stove-bolt and two nuts is shown. The under bolt is screwed down tightly against the wood, and under the head a wire is made fast, so that another wire may be caught under the upper nut. If a small thumb-nut can be had in place of the plain nut, it will be easier to bind the upper wire. In Fig. 17 E a thin strip of metal may be folded over, and at the loose ends a hole should be punched through which a screw-eye will pass. The metal is held to a wood base with a screw, under the head of which a wire is caught. The second wire end is slipped between the metal plates, and a turn of the screw-eye will bind and hold it securely.

Connectors are employed to unite the ends of wires temporarily, and are made in many forms. A simple and useful one is made from a piece of spiral spring fastened to a block of wood by two staples, as shown at Fig. 18 A. The ends of the wires are pressed down into the coils of the spring and are held with sufficient security for temporary use. Another connector is made from a block of wood, a strip of thin metal, and two screw-eyes (Fig. 18 B). The metal is bent around the ends of the block, and through holes made in the ends of the strip screw-eyes are driven into the block. When the ends of wires are slipped under the metal, a turn of the eyes will hold them fast, as shown at Fig. 18 B.

A short bolt threaded at each end and provided with four nuts will also act as a connector. The inner nuts are screwed on tightly and the outer ones are loose, so that when wires are placed between them they may be tightened with the fingers, as shown at C in Fig. 18. These are a few simple forms of connectors; the ingenious boy can devise many others to suit his needs and ideas.