Читать книгу Bolt Action Rifles - Wayne Zwoll - Страница 33

Mauser 71/84

General Specifications

Type . . . . . . . . . . .Turnbolt repeater.

Receiver . . . . . . . .One-piece machined steel forging. Slotted bridge.

Bolt . . . . . . . . . . . .Two-piece with separate non-rotating bolt head. Rib on bolt body forms the only locking lug, engages in front of receiver bridge wall.

Ignition . . . . . . . . .One-piece firing pin powered by coil mainspring. Cocks on opening of the bolt.

Magazine . . . . . . . .Tubular magazine in forend. Cartridges transported from magazine to chamber by carrier (lifter).

Bolt-stop . . . . . . . .Screw and washer on the bolt body stop bolt as the washer contacts groove on receiver bridge.

Trigger . . . . . . . . . .Non-adjustable, two-stage military type.

Safety . . . . . . . . . .Swinging wing-type built into cocking piece. Locks striker and bolt when swung right.

Extractor . . . . . . . .One-piece spring type fitted into bolt head.

Magazine cutoff . .Lever type disengages carrier when pushed forward.

Ejector . . . . . . . . . .Sliding type fitted to bolt.

To disassemble the bolt: Lift up the rear end of the ejector and remove it from the bolt. Turn the bolt head one-quarter turn in either direction and pull it from the bolt body. The extractor can then be lifted from the bolt head. Now, rest the firing pin tip on the workbench, and while pressing down on the safety with the thumb of the hand grasping the bolt, unscrew the firing pin nut.

After the nut is removed, the firing pin and mainspring can be removed from the bolt and the safety removed from the cocking piece. Reassemble in reverse order.

To remove the barrel and action from the stock: Remove the small screw from the left side of the muzzle barrel band and drive out the cross-key to the left. Slide the muzzle band off the barrel. Also, remove the other barrel band or bands. Pull out the magazine tube about 1”. Turn out the front and rear trigger guard screws; the barrel and action can now be lifted from the stock. Turn out the center guard screw and the trigger guard can be removed. Reassemble in reverse order.