Читать книгу Open and Toroidal Electrophoresis - Tarso B. Ledur Kist - Страница 17

Ionic liquids and ionic solids are predominantly made by cations and anions that are held together by electrostatic attraction. This is the state of salts and even some bases and acids. They tend to stay in this state when mixed with most solvents at room temperature. The thermal motion of the solvent molecules, even at room temperature, continuously pushes ions from the edges and corners of these ionic solutes due to inelastic collisions. In most solvents the electric restoring force, given by equation 1.1, pulls the the ions back. Within water, however, two things happen:

1 The detached ions are immediately subjected to solvation

2 The restoring force is much weaker because the relative permittivity () of water is very high (equation 1.1).

These two properties of water make it a very good solvent for the dissociation of ionic liquids or ionic solids at room temperature.

As well as looking at the forces involved, another way to understand the unique ability of water to dissociate ionic liquids and solids is to examine the energies involved. Again, suppose that an ion is momentarily separated by thermal energy from a vertex or edge of a small neutral crystal stone of a solute. The detached ion is then immediately solvated and is initially positioned at distance , in close contact with the crystal. The energy necessary to move this ion from this position () to infinity is found by replacing by in equation 1.1 and integrating it over , from to infinity. The result is given by:

(1.2)

This is the energy necessary to move the ion with charge , and the resulting oppositely charged small crystal with charge from to infinity. From Table 1.1 is possible to see that in water this required energy is 10 times smaller than what would be necessary, for instance, to perform the same operation in tetrahydrofuran, which has a relative permittivity of 7.6. All of this was calculated without counting the solvation phenomena, which favors water over most other solvents. In conclusion, both the electric forces among ions and the electrostatic energy change, which occurs when separating these ions from each other, is much smaller inside water than most of the solvents that are liquid at room temperature and one atmosphere of pressure.

Therefore, a large quantity of ionic liquids and ionic solids, with molecular formula , are subjected to dissolution via a dissociation reaction when mixed in water. At the saturation point the following equilibrium is observed:

The maximum solubility of ionic liquids and ionic solids is an important parameter in practical preparative and analytical applications of ESTs. For instance, some analytes are not soluble above certain concentrations, which must be known to avoid errors in the analysis. The same is true for buffers within certain temperature ranges. The maximum solubilities of analytes and buffers at a given temperature are tabulated in the literature and are usually expressed in grams per 100 milliliters of solution.

Another way to express maximum solubility is the so-called solubility product, which is defined as . This is also well recorded in the literature and is very useful for the theoretical modeling of problems in inorganic chemistry.

The above paragraphs merely give qualitative discussions of the phenomena involved in dissociation reactions. Gibbs free energy change can actually be used to accurately predict if a reaction (dissolution with dissociation) may occur or not (see Section 1.1.8). It is fair to make a clear distinction between dissociation and ionization. The so-called ionic substances (liquids or solids) are predominantly in the form of cations and anions. Therefore, their solubilization in water is merely dissolution with dissociation. On the other hand, a large number of substances are predominantly in the form of covalent liquids, solids, or even gases. Only when placed in water (and a few other solvents) do they ionize to the form of cations and anions. In this case the process is better called dissolution by ionization.