Читать книгу Automatic Pistols Assembly/Disassembly - J B Wood - Страница 65

Detail Strip:

5. Drifting out this cross-pin in the slide will allow the extractor and its coil spring to be taken out upward.

6. The safety lever can be lifted out of the frame.

7. Remove the grip screws, and take off the grips. Drift out the magazine catch limit pin.

8. Drift out the magazine catch pivot pin.

9. Remove the magazine catch downward, and take out the catch and grip safety spring, and its plungers.

10. Note that the spring plungers are not identical. The larger flat one at the top powers the grip safety, and the smaller rounded one powers the catch. Also note that in earlier pistols with the “hump” grip safety, each part has its own separate spring.

11. Drift out the grip safety cross-pin.

12. Remove the grip safety toward the rear. In pistols with the “Hump” type, the part is moved forward, into the magazine well, for removal.

13. Drift out the sear cross-pin. The other cross-pin, below, is the sear limit pin. It does not have to be removed in normal takedown.

14. Tip the sear forward into the magazine well, and move it slightly to the right to clear its side-lug for removal. Note that the coil sear spring may or may not come out with the sear. It will be released, so take care that it isn’t lost.

15. Remove the sear spring.

16. Drift out the trigger cross-pin.

17. Move the trigger assembly toward the rear, lifting the rear tip of the trigger bar very slightly, just enough to clear the side of the frame. Take out the trigger assembly.

18. The trigger bar and its spring and plunger can be removed from the trigger by drifting out the cross pin. CAUTION:Control the plunger and spring.