Читать книгу The Gun Digest Book of Rimfire Rifles Assembly/Disassembly - J.B. Wood - Страница 24

Reassembly Tips:

1. After the sear is installed, flip it over and insert the spring, then rotate it back into position, and insert a tool from the top to nudge the spring onto its plate inside the frame.

2. After the hammer is installed, tip its spring guide upward, and fit the spring and lower guide onto it.

3. Swing the mainspring assembly downward, with the lever in closed position. Pull the trigger to release the hammer, and tip it forward beyond its normal lowered position. Snap the nose of the lower spring guide into its recess on the lever. Open the lever, and insert a fingertip to support the underside of the spring while slowly cocking the hammer. Caution: If solid resistance is felt, stop and be sure that the spring is being kept straight (it will tend to bow downward).

4. When replacing the locking block on the lever link, note that its side projection must be at the right rear, as shown.

5. Grip the ejector spring with forceps or sharp-nosed pliers for insertion. The same procedure can be used for the ejector. When the spring and ejector are in place, insert a fingertip through the ejection port to hold them while sliding the bolt and sub-frame back in.

6. When replacing the carrier and lever link, be sure the pointed front arm of the lever link lies on top of the carrier guide pin.