Читать книгу The Gun Digest Book of Rimfire Rifles Assembly/Disassembly - J.B. Wood - Страница 30

Reassembly Tips:

1. When replacing the ejector in its slot in the underside of the receiver, be sure its vertical face is toward the front, and its angled end toward the rear, as shown.

2. When replacing the trigger and its spring, taking out the trigger stop pin will make this operation easier. Insert the cross pin from the right, just far enough to hold the spring in position, then put in the trigger, and move the cross pin the rest of the way across. Be sure the front arm of the spring is against its shoulder or shelf inside the housing.

3. When replacing the locking cross bolt in the body of the bolt, note that the face with the deep cut and hole must be oriented toward the rear, and install the locking bolt before the firing pin is returned to its channel.

4. When replacing the bolt handle, be sure its front projection enters the hole in the rear face of the locking bolt, and note that the handle must be in the unlocked position, as shown, when the bolt is inserted into the receiver.